Sidewinder Gauge Pod Installation

Sidewinder Gauge Pod Installation

Kit Contents:

Gauge pod

Drill template

Vehicle specific adapter

(2) mounting bolts

Step 1: Remove A-Pillar and match up drill template with positioning cutout. Drill templates and adapters are vehicle specific and should only match up one way (wording right side up). The drill template should be placed 8in(99-04) or 6.75in (94-98) up from bottom of pillar. They are modeled using 3D scans to perfectly match the contour of your specific pillar.     

Step 2: Using the same size drill bit as holes in the Drill template, drill your two mounting holes and one wire pass-through hole.

Step 3: Assemble vehicle specific adapter against pillar, along with gauge pod on the outside. Using the supplied hardware, thread bolts from backside of pillar to clamp piller,adapter, and pod together. Tighten until the gauge pod is snug and will not move. 

Step 4. Thread gauge wiring through front of pod and out of wire pass-through hole to backside of pillar. Reassemble pillar in reverse order and continue wiring gauges per manufacturer specifications. 

Thank you so much for choosing Venom Prototyping!